To Next PageTo Next Page
Need help?Do you have a question about the EMS AIR-FLOW MASTER PIEZON FT-200 and is the answer not in the manual?
General| Category | Dental equipment |
|---|---|
| Water Pressure | 1 to 2 bar |
| Frequency | 24 – 32 kHz |
| Power Supply | 100–240 V~ 50/60 Hz |
| Operating Modes | AIR-FLOW |
Details the indications for use of the Piezon system in dentistry.
Details the applications of the AIR-FLOW system for dental treatments.
Details the applications of the PERIO-FLOW system for subgingival dental treatments.
Instructions for preparing the Piezon system for dental treatment.
Guidance on how to install the solution bottles into the Piezon system.
Lists solutions recommended for disinfecting the treatment circuit.
Provides examples of commonly used disinfecting products.
Lists solutions recommended for washing the liquid circuit.
Warns about potential reactions from mixing different disinfecting solutions.
Instructions for connecting and installing the foot pedal.
Instructions for preparing the Piezon system for dental treatment.
Guidance on how to install the solution bottles into the Piezon system.
Steps for disassembling and cleaning the handpiece after treatment.
Detailed instructions for using the 'Cleaning' mode to wash and disinfect the circuit.
Instructions for performing the rinsing cycle after disinfection.
Details the specific use of the AIR-FLOW CLASSIC+SOFT powder chamber.
Details the specific use of the AIR-FLOW PERIO+PLUS powder chamber.
Information on using powders for supragingival treatments.
Instructions for cleaning the powder reservoir and its parts.
Procedure for turning the unit on and its initial status.
Instructions for purging powder and water from the AIR-FLOW circuit.
Instructions for cleaning the powder reservoir and its parts.
Indicates compliance with Russian standards for products.
Indicates compliance with Canadian and US standards for products.
Indicates compliance with Brazilian electrical standards for products.
Solutions for issues where the unit fails to start or stop.
Troubleshooting steps if the foot pedal is not activating the unit.
Solutions for when the unit remains active after releasing the foot pedal.
Troubleshooting steps for interface errors indicated by sound and blinking LEDs.
Solutions for when the handpiece does not stay on the magnetic support.
Troubleshooting steps when the handpiece does not secure to the handpiece cord.
Steps to resolve issues with no or low ultrasound oscillations.
Solutions for inadequate lighting from the handpiece.
Guidance for the blinking LED indicating the cleaning mode.
Troubleshooting steps if no water jet emerges from the Piezon handpiece.
Solutions for when no powder/air jet comes from AIR-FLOW or PERIO-FLOW.
Troubleshooting steps for water leakage between the handpiece cord and handpiece.
Solutions for water leakage between PERIO-FLOW handpiece and nozzle.
Troubleshooting steps for air and powder leakage from the main unit.
Solutions for air and powder leakage from the powder chamber.
Troubleshooting steps when handpiece efficiency decreases.
Solutions for leakage on the unit's water supply.
