ENCLO EC18017 - Assemble First Panel; Position Posts; Attach Top Rail

www.encloscreens.com
ASSEMBLY INSTRUCTIONSEC18017 / EC18018
6
STEP 3: ASSEMBLING THE FIRST PANEL
STEP 3.1
A
B
Note: This will
be the top of the
screen.
STEP 3.2
1. Slide (1) Rail (C) into the post channels until the pre-drilled holes in the rail and the single
holes at the tops of the posts align.
2. Drive (2) total 1” Black Stainless Steel Screws (G) into the pre-drilled holes in the posts.
Note: This will be the
bottom of the screen
1
2
G
C
Align
Posion (1) Post (A) and (1) Post (B) so the pre-drilled holes for both posts face forward and the
open channels face towards each other as shown. It is recommended to assemble your panels on a at
smooth surface.