Connect the Internet Broadband Router
1. Plug in one end of the network cable to the WAN port of the 4-port
Internet Broadband Router.
2. Plug in the other end of the network cable to the Ethernet port of the
xDSL or Cable modem.
3. Use another network cable to connect to the Ethernet card on the
computer system; the other end of the cable connects to the LAN port
of the Internet Broadband Router. Since the Internet Broadband
Router has four ports, you can connect up to four computers directly
to the unit. There you do not have to buy a switch to connect these
computers since one Internet Broadband Router functions both as a
connection-sharing unit and as a switch.
Check the installation
The control LEDs of the Internet Broadband Router are clearly visible and
the status of the network link can be seen instantly:
1. With the power source on, once the device is connected to the
broadband modem, the Power, CPU, LAN and WAN port link LEDs
of the Internet Broadband Router will light up indicating a normal
status.
2. While the WAN is link up to the ADSL/Cable modem, the WAN
port’s Link/ACT LED will light up.
3. While the LAN is link up to the computer system, the LAN port’s
Link/ACT LED will light up.
9
To Next Page
Loading...
Need help?
General
