INTERNET BROADBAND ROUTER CONFIGURATION
First make sure that the network connections are functioning normally.
This Internet Broadband Router can be configured using Internet Explorer
4.0 or newer web browser versions.
Login to the Internet Broadband Router
Before you configure this device, note that when the Broadband Router is
configured through an Ethernet connection, make sure the host PC must
be set on the IP subnetwork that can be accessed by the xDSL/Cable
modem. For example, when the default network address of the
xDSL/Cable modem Ethernet interface is 192.168.1.x, then the host PC
should be set at 192.168.1.xxx (where xxx is a number between 2 and
254), and the default subnet mask is 255.255.255.0.
1. Open Internet Explorer 4.0 or above Internet browser.
2. Enter IP address
http://192.168.1.1 (the factory-default IP address
setting) to the URL web address location.
3. When the following dialog box appears, remain blank (first login) or
enter the password and press Login to enter the main configuration
window.
Note: If needed to set a password, then refer to the Administrator
Setting.
15
To Next Page
Loading...
Need help?
General
