BELT-DRIVE WALK BEHIND MOWER
14
CAUTION
If the ignition is in the “ON” position
there is potential for sparks and
engagement of components. Sparks
could cause an explosion or moving
parts could engage causing personal
injury.
Be sure ignition switch is in the “OFF”
position before charging the battery.
WARNING
Removing standard, original equipment
parts and accessories may alter the
warranty, traction, and safety of the
machine. Unauthorized changes to the
engine, fuel or venting system, may
violate EPA and CARB regulations.
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury. Fluid
accidentally injected into the skin must be
surgically removed within a few hours by a
doctor familiar with this form of injury or
gangrene may result.
• Make sure all hydraulic fluid hoses and
lines are in good condition and all
hydraulic connections and fitting are
tight before applying pressure to
hydraulic system.
• Keep body and hands away from pinhole
leaks or nozzles in components charged
with high pressure hydraulic fluid.
• Use cardboard or paper, not your hands,
to find hydraulic leaks.
• Safely relieve all pressure in the
hydraulic system by placing the motion
control levers in neutral and shutting off
the engine before performing any work
on the hydraulic system.
To Next Page
Loading...
Need help?
General
