Endorphin.es GHOST - P R E S E T S L O a D; S a V E

HARD RESET : press all four buttons (13) (15) (19) (23) simultaneously and hold
them for more than 10 seconds. Module will erase all its presets to default empty
ones and all the MIDI settings to default as well.
After the module’s reset: FILTER , DELAY’s , REVERB’s and DISTORTION’s /TONE*
controls are in the middle (no filtering applied); MIX and VOLUME controls set to
100% (CW value) and cabinet simulator set to 0 (off).
PRESETS LOAD / SAVE
Ghost pedal has 9 preset slots: which correspond to 3x3 LEDs array (25) above the
PRESET footswitch (24). You may still play with the current preset but only select
the new slot to load. Preset selection and saving is made with the idea to be
operated with one foot only.
TO LOAD A PRESET
🠚 shortly press PRESET footswitch (24) a few times to move the blinking LED over
to one of nine slots you wish to load.
🠚 Press BYPASS footswitch (20) and the new preset will be loaded. All the
parameters which have continuous changes will slew to the new preset values to
avoid any clicks.
🠚 NOTE: loading the new preset with a single BYPASS footswitch (20) confirmation
will not alter current bypass effect state on or off.
Once you make any changes to the knobs on your GHOST Pedal (see SETTINGS
AUTOSAVE section below) you wish to recall later, you have to save them. If the
changes were not saved, you will have a previously saved preset recalled on the
next pedal startup.
TO SAVE THE PRESET
🠚 Hold the PRESET footswitch for longer than 3 seconds: one of the 9 slots will
start to blink
🠚 You may choose the new slot to save by shortly pressing the PRESET (20)
footswitch a few times.
🠚 To confirm the preset save in the selected slot press and hold PRESET
footswitch for longer than 3 seconds.
🠚 (1) NOTE: when SHIFT button is enabled, pressing the PRESET footswitch will
select the presets in the reverse direction.
Page 18 of 27