Endorphin.es GHOST - S U a L I Z I N G T H E R E a L T I M E V a L U E; D I S T O R T E D R E a L I T

🠚 when SHIFT button is enabled, pressing the PRESET (20) footswitch will
select the presets in the reverse direction.
25. 9 PRESET LEDS: nine white LEDs show the currently selected preset
slot and blink when you select the new one without activating it yet.
VISUALIZING THE REAL TIME VALUES
You may notice each knob has an LED next to it which can become of different
brightness of blue , red or a mixture of both colors - fuchsia .
When you change the preset or apply modulation you may see those LEDs will
change their brightness or will be breathing . Those are real time parameter’s change
visualization while the physical knobs remain motionless.
Since each knob may set various parameters: primary, secondary and modulation
depth, the current physical knob position may not always reflect its real parameter
value. That’s where the LEDs come to help.
Primary parameters are written in capitals: VOLUME, DELAY, TIME, REPEATS,
REVERB, DECAY, FILTER, DISTORTION and MIX are shown with the brightness
of the blue LED.
Secondary parameters are labeled with an asterisk /…* next to the primary
parameter: /crush*, /midi clk*, /tone*, /taps*, /predelay*, /reso*, /midi ch*,
/cabinet* . They and are set in combination with the SHIFT /* button and are shown
with the brightness of the red LED.
Some parameters have a bipolar nature with an important center position: LP/HP
FILTER and all /tone* controls of the DELAY , REVERB and DISTORTION pass clear
unaffected sound when they are in the center position. The LED becomes fuchsia
when that certain parameter stands exactly in or crosses the center value.
Also some parameters have discrete values : i.e. not a continuous change but a
selection of a few parameters placed around the knob moving range: /midi clk*,
/taps*, /midi ch*, /midi clk* . You will see LED shortly blinking fuchsia when we
move to the next settings from the list.
DISTORTED REALITY
The power of the GHOST PEDAL lies in its stereo complex audio effect chain with
96kHz, 32-bit internal audio processing, consisting of 8x oversampled distortion
algorithm with cabinet simulator and bitcrusher , a multimode filter , delay , reverb
and a modulator - LFO . All the knobs positions and settings can be saved and
recalled from 9 presets slots. The order of the three main processing blocks -
Page 10 of 27