🠚 (2)
NOTE:
there is a blinking LED timeout when you started to load or save a
preset and LED is blinking asking for load confirmation with
BYPASS
or save
confirmation with
PRESET
footswitches - after approximately 15 seconds it will
return to a normal state without any load or save.
PRESETS DUMP / UPLOAD
It is possible to transfer all 9 presets from and to the pedal on either Windows or
Mac computer by using MIDI SysEx dump. This can be done using free software
available for both Mac and Windows.
SYSEX PRESETS DUMP SAVE ON MAC
🠚 Download and install
SYSEX LIBRARIAN
app your Mac:
https://www.snoize.com/sysexlibrarian/
🠚 Connect the
MIDI IN/OUT
ports on the pedal to your Mac via a USB MIDI cable
or by using your midi interface so the
MIDI IN
jack is connected to
MIDI OUT
on
the pedal and
MIDI OUT
jack is connected to
MIDI IN
on the pedal.
🠚 Open SysEx Librarian app and select your MIDI interface from the drop-down
menu list to send a receive SysEx.
🠚 Press
RECORD MANY
and the app will be waiting for the SysEx message to
record.
🠚 To perform a preset dump, hold the
SHIFT
+
ROUTING
buttons for a few
seconds until you see the 9 preset LEDs are on for a moment. You should see the
MIDI data being received inside the SysEx Librarian app so you can save it as a
*.syx file afterwards.
SYSEX PRESET UPLOAD ON MAC
🠚 To upload the presets to the pedal, press the
File
menu in the top menu select
Add to library
in the drop down menu. Select the file you want to transfer from the
list and press
Play
in the top left side of the app. All 9 preset LEDs should light up
on the pedal to confirm the transfer.
To Next Page
Loading...