🠚 If you are experiencing issues during the preset upload, try adjusting the
Send
MIDI Buffer
inside the Options menu on to 100 msec.
SYSEX PRESETS DUMP SAVE ON WINDOWS
🠚 Download and install
BOME SENDSX
software on your PC computer:
https://www.bome.com/products/sendsx
🠚 Connect the MIDI IN/OUT ports on the pedal to your Mac via a USB MIDI cable
or by using your MIDI interface so the MIDI IN jack is connected to MIDI OUT on the
pedal and MIDI OUT jack is connected to MIDI IN on the pedal.
🠚 Open Bome SendSX software and configure in the top menu the MIDI IN and
MIDI OUT ports to send a receive SysEx to your connected MIDI interface device.
🠚 To perform a preset dump, hold the
SHIFT
+
ROUTING
buttons for a few seconds
until you see the 9 preset LEDs light up. You should see the midi data being
received in the MIDI IN window inside the Bome SendSX software.
🠚 Save the presets on your computer by pressing the
File
menu in the top left
corner of the Bome SendSX and select
Save Midi In As…
in the drop down menu.
SYSEX PRESET UPLOAD ON WINDOWS
🠚 To upload the presets to the pedal, press the
File
menu in the top left corner of
the Bome SendSX and select Open in the drop down menu. Once you have
selected your preset bank file in .syx format, press
Send (F4)
in the lower left side of
the program. All 9 preset LEDs should light up on the pedal to confirm the transfer.
🠚 If you are experiencing issues during the preset upload, try adjusting the Send
MIDI Speed inside the Options menu on Bome Send SX to around 1.29KB/s.
SETTINGS AUTOSAVE
There are a few layers of data and settings GHOST pedal can save and recall on the
next power up cycle. Some of them you may change using the controls of the pedal
and some of them are accessible via MIDI CC# messages (see
MIDI
IMPLEMENTATION CHART
below).
To Next Page
Loading...