Why is my Endress+Hauser Deltabar S FMD78 Alarm Status not displaying the expected message priorities?
The Alarm Status/ALARM_STATUS parameter in Endress+Hauser Measuring Instruments shows the message with the highest priority. Check if the expected message has the highest priority.
General| Device Type | Differential Pressure Transmitter |
|---|---|
| Housing material | Aluminum, stainless steel |
| Application | Level, volume or mass measurement in liquids |
| Measuring principle | Piezoresistive |
| Measuring range | up to 40 bar (600 psi) |
| Long-term stability | ±0.1% of URL per year |
| Process Temperature | -40 to +120 °C (-40 to +248 °F) |
| Process Connection | Flanged, hygienic, or threaded |
| Output signal | 4-20 mA HART, PROFIBUS PA, FOUNDATION Fieldbus |
| Sensor material | 316L stainless steel |
| Material | Stainless steel |
| Enclosure Rating | IP66/IP67, Type 4X |
| Approvals | ATEX, IECEx, FM, CSA |
To Next Page
