Why is my Endress+Hauser Deltabar S FMD76 Measuring Instruments Alarm Status not displaying the expected message priorities?
The Alarm Status/ALARM_STATUS parameter in Endress+Hauser Measuring Instruments shows the message with the highest priority. Check if the expected message has the highest priority.
General| Device Type | Differential Pressure Transmitter |
|---|---|
| Process Pressure Limit | up to 400 bar (5800 psi) |
| Communication | HART, PROFIBUS PA, FOUNDATION Fieldbus |
| Housing Material | Aluminum, stainless steel |
| Application | Level, volume or mass measurement in liquids |
| Measuring Range | up to 40 bar (580 psi) |
| Process Temperature | -40 to 120 °C (-40 to 248 °F) |
| Accuracy | ±0.075% |
| Output Signal | 4...20 mA HART |
| Power Supply | 10.5 to 45 V DC |
| Sensor Type | Piezoresistive |
| Long-term stability | ±0.1% of URL/year |
| Reference accuracy | ±0.075% of span |
| Process Connection | Threaded and flange connections |
| Protection Class | IP66 |
| Material | 316L |
To Next Page
