Installation instructions TMT162 HART
20 Endress+Hauser
2 Installation instructions
2.1 Quick installation guide
If stable sensors are used, the device can be fitted directly to the sensor. For remote mounting
to a wall or stand pipe, two mounting kits are available (see Fig. 3). The illuminated display can
be mounted in four different positions:
T09-TMT162ZZ-11-00-00-xx-001
Fig. 1: Temperature field transmitter with sensor, 4 display positions, can be plugged-in in 90° steps
Pos. A: Sensor
1. Remove the cover clamp (1).
2. Unscrew the housing cover together with the O-ring (2).
3. Remove the display with retainer and twist protection (3) from the electronics module (4).
Adjust the display with retainer in 90°stages to the desired position and rearrange it on the
particular slot on the electronics module.
4. Then screw on the housing cover together with the O-ring. Mount the cover clamp.
To Next Page
Loading...
