Endress+Hauser Promag Series - User Manual

Products Solutions Services
Conversion Instructions
Conversion transmitter Promag 50/53 W, P, H to Promag 55 remote version
Promag 50W, P, H, 53W, P, H
Instruction is valid for the following conversion kit:
Overview of the personnel authorized to carry out conversion
Authorization to carry out conversion depends on the approval of the measuring device. The table shows the respective group of persons
for each.
The person who carries out conversion is responsible for safety during the work, the quality of work completed and safety of the device
after conversion.
Transmitter that can be used for the conversion
The transmitter for the conversion has to be ordered seperatly. Only transmitter with the following order code can be used:
Order-Code Conversion kit
DK5UP8
1 × notice label for the sensor
1 × form data storage
1 × conversion instruction
Approval of the measuring device Group of persons authorized to carry out conversion
without approval 1, 2, 3
with approval FM/CSA Div. 2 1, 2, 3
1 Trained customer technician
2 Service technician authorized by Endress+Hauser
3 Endress+Hauser (send measuring device back to manufacturer)
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
Order-Code
Transmitter
Promag
55XXX–XXXXXA, R C, S, 3 *****
NOTICE
NOTICE
EA00059D/06/A2/13.15
71294946

Summary

Overview of the personnel authorized to carry out conversion

Transmitter that can be used for the conversion

Safety instructions

Information about the modified device

Relevant documentation

Specifies required documentation for sensor and transmitter.

Changes and restrictions conditioned by conversion

Details accuracy changes and conversion restrictions.

Preparatory operations: Save device data

Conversion Promag 50

Save parameters for Promag 50 conversion.

Conversion Promag 53

Save parameters for Promag 53 using T-DAT.

Overview data storage (Histo-ROM) and F-CHIP

Disassambling the transmitter Promag 50, 53

Assembly the transmitter

Commissioning the device

Changing the identification

Change of device roots and;or order codes

Mandatory instruction

Procedure for updating device root and order codes in the database.

Endress+Hauser Promag Series Specifications

General

Measurement Principle	Electromagnetic
Output	4 to 20 mA
Communication Protocols	HART, PROFIBUS DP, FOUNDATION Fieldbus, Modbus
Enclosure Rating	IP67, NEMA 4X
Display	LCD with backlight
Housing Material	Aluminum, stainless steel
Ambient Temperature	-40°C
Repeatability	±0.1% of reading
Communication	HART, PROFIBUS DP, FOUNDATION Fieldbus, Modbus