TMT162 HART Commissioning
Endress+Hauser 29
Display symbols
4.3.2 Local operation, setup of the hardware
T09-TMT162ZZ-19-00-00-xx-001
Fig. 9: Hardware setup using jumpers J1, J2 and J3
Pos.
no.
Function Description
1 Bargraph display In 10% steps with overrange and underrange marks.
The bargraph display flashes when an error occurs.
2 Display ’Warning’ This display mode appears when an error occurs or a
warning is given.
3 Engineering unit display K, °F, °C or % Engineering unit for the measured value being
displayed.
4 Measured value display
(0.81" / 20.5 mm character size)
Measured value display. If a warning is present this
display alternates between the measured value and the
warning code. In the event of an error, the error code
is dispalyed instead of the measured value.
5 Status and information display Display of which value is being indicated on the
display. On PV a customer specific text can be entered.
On warning, the display shows the warning code as
well as "WARN". On faults the display shows
"ALARM".
6 Display "Communication" The communication icon appears on read or write
access using the HART
®
protocol.
7 Display "Configuration locked" If the software or hardware setup/configuration is
locked, the "Configuration locked" icon appears.
To Next Page
Loading...
