To Next PageTo Next Page
Why is my Endress+Hauser Radar measuring incorrectly?
If your Endress+Hauser Radar device is measuring incorrectly, it might be due to a parameter configuration error. Review the parameter configuration and correct any mistakes.
What to do if Endress+Hauser Radar displays a communication error?
If the display shows 'Communication error' when starting the device or connecting the display on your Endress+Hauser Radar, the issue may be electromagnetic interference. Check the grounding of the device. Alternatively, the display cable or plug might be broken, in which case you should replace the display.
How to troubleshoot an Endress+Hauser Radar device that does not respond?
If the Endress+Hauser Radar device does not respond, it could be due to the following reasons: * The supply voltage is not connected. Connect the correct voltage. * The cables do not contact the terminals properly. Ensure electrical contact between the cable and the terminal.
How to fix invisible values on Endress+Hauser Radar display?
If the values on the display of your Endress+Hauser Radar are invisible, the contrast setting may be too weak or too strong. Try these steps: * Increase the contrast by pressing the designated buttons simultaneously. * Decrease the contrast by pressing the designated buttons simultaneously. Alternatively, the display cable plug might not be connected correctly, so ensure it is properly connected. If the issue persists, the display may be defective and require replacement.
Why CDI communication is not working on Endress+Hauser Radar?
If CDI communication does not work with your Endress+Hauser Radar, the COM port setting on your computer may be incorrect. Check the COM port setting and change it if necessary.
What to do if parameter duplication is not working on Endress+Hauser Radar?
If the duplication of parameters via display from one device to another is not working on your Endress+Hauser Radar and only the 'Save' and 'Cancel' options are available, it could be because the display with backup is not properly detected if a data backup was not carried out on the new device previously. Connect the display (with backup) and restart the device.
General| Measuring Principle | Guided radar |
|---|---|
| Application | Level measurement in liquids |
| Measuring Range | Up to 30 m |
| Process Temperature | -40 to +80 °C |
| Process Pressure (absolute) | Up to 40 bar (580 psi) |
| Main wetted parts | Stainless steel, PTFE |
| Communication | HART, PROFIBUS |
| Accuracy | ± 2 mm |
| Power Supply | 10.5 to 35 V DC |
| Protection Rating | IP66/IP68 |
