Need help?Do you have a question about the Endress+Hauser Liquiline CA80SI and is the answer not in the manual?
Requirements for personnel, designated use, and occupational safety conditions.
Safety during operation, product safety features, and IT security measures.
Covers mounting options, dimensions, spacing, and site requirements.
Step-by-step instructions for wall mounting, analyzer stand, and panel installations.
Details power supply, cable routing, sensor/module connections, and digital communication.
Basic settings, date/time, analyzer configuration, measurement, and calibration.
General| Power Supply | 24 V DC |
|---|---|
| Measured Variables | Conductivity |
| Measuring Range | 0 to 200 mS/cm |
| Measurement Range (General) | 0.0005 to 5 mg/l SiO₂ |
| Accuracy | ±1% of measured value |
| Accuracy (General) | ±1% of measured value |
| Repeatability | ±0.5% of measured value |
| Resolution | pH: 0.01, Conductivity: 0.001 μS/cm, DO: 0.01 mg/L, ORP: 1 mV |
| Ambient Temperature | -20°C to +60°C |
| Operating Temperature | -20°C to +60°C |
| Output Signal | 4 to 20 mA |
| Communication | HART, PROFIBUS PA, Modbus, Ethernet/IP |
| Communication Protocol | HART, PROFIBUS PA, Modbus, Ethernet/IP |
| Protection | IP66 |
| Housing Material | Polycarbonate |
To Next Page