Liquiline System CA80SI Diagnostics and troubleshooting
Endress+Hauser 125
12.10 System information
DIAG/System information
Function Options Info
Device tag Read only Individual device tag → General settings
Order code Read only You can order identical hardware with this code.
This code changes on account of changes to the
hardware and you can enter the new code you
received from the manufacturer here
1)
.
To establish the version of your device, enter the order code into the search screen at the following
address: www.endress.com/order-ident
Orig. order code ext. Read only Complete order code for the original device,
resulting from the product structure.
Current order code ext. Read only Current code, taking into account changes to the
hardware. You must enter this code yourself.
Serial number Read only The serial number allows you to access device
data and documentation on the Internet:
www.endress.com/device-viewer
Software version Read only Current version
Measuring parameter Read only Set measuring parameter
MPL version Read only Current version
FXAB1 control module Read only
• Firmware version
• Hardware version
Photometer Read only
• Firmware version
• Hardware version
Modbus
Only with the Modbus option
Read only
• Enable
• Bus address
• Termination
• Modbus TCP Port 502
Modbus‐specific information
PROFIBUS
Only with the PROFIBUS option
Read only
• Termination
• Bus address
• Ident number
• Baudrate
• DPV0 state
• DPV0 fault
• DPV0 master addr
• DPV0 WDT [ms]
Module status and other PROFIBUS-specific
information
Ethernet
Only with the Ethernet,
EtherNet/IP, Modbus TCP,
Modbus RS485 or PROFIBUS
DP option
Read only
• Enable
• Webserver
• Link settings
• DHCP
• IP-Address
• Netmask
• Gateway
• Service switch
• MAC-Address
• EtherNetIP Port 44818
• Modbus TCP Port 502
• Webserver TCP Port 80
Ethernet‐specific information
Display depends on the fieldbus protocol used.
SD card Read only
• Total
• Free memory
To Next Page
Loading...
