Endress+Hauser Liquiline CA80SI - Mounting Procedures

Installation Liquiline System CA80SI
20 Endress+Hauser
6.1.3 Spacing requirements when mounting
Spacing required for installing analyzer
≥330(12.99)
≥100 (3.94)
A0036774
 15 Minimum spacing required for mounting. Engineering unit
mm (in).
≤116 °
A0036775
 16 Maximum opening angle
Spacing required for installing wall-mount version
750 (29.53)
120 (4.72)
Ø 11 (0.43)
Ø 10.7 (0.42)
A0036779
 17 Holder unit dimensions. Engineering unit mm (in)
6.2 Mounting the analyzer on a wall
L
CAUTION
Incorrect installation can cause injury and damage the device
‣
If mounting on a wall, check that the analyzer is fully hooked into the wall holder unit
at the top and bottom, and secure the analyzer to the upper wall holder unit using the
securing screw.
The mounting materials required to secure the device to the wall are not supplied.
‣
The mounting materials to secure the device to the wall (screws, wall plugs) must be
provided by the customer onsite.