Endress+Hauser Liquiline CA80SI - Page 19

Liquiline System CA80SI Installation
Endress+Hauser 19
54 (2.13)
49 (1.93)
15,5
(0.61)
63,5 (2.5)
A0036664
 12 Dimensions of angle bracket for pressure relief valve
--- Fasteners (2 x M5)
196
(7.72)
355
(13.98)
8 (0.31)
95
(3.74)
335 (13.19)
176 (6.93)
A0036389
 13 CA80SI 4-/6-channel version: Panel with pressure-reducing valves and filters, dimensions in mm (in)
230
(9.06)
255 (10.04)
8 (0.31)
74
150
(5 91)
235
(9.25)
(2.91)
A0036390
 14 CA80SI 4-/6-channel version: Panel with sample channel switching, dimensions in mm (in)
6.1.2 Installation site
Note the following when erecting the device:
1. If mounting on a wall, make sure that the wall has sufficient load-bearing capacity
and is fully perpendicular.
2. If mounting on a base, erect the device on a level surface.
3. Protect the device against additional heating (e.g. from a heating system).
4. Protect the device against mechanical vibrations.
5. Protect the device against corrosive gases, e.g. hydrogen sulfide (H
2
S) and chlorine
gases.
6. Ensure that sample outlet hose "D" and outlet hose "W" can drain freely , without any
siphoning effects.
7. Make sure air can circulate freely at the front of the housing.
8. Open analyzers (i.e. analyzers that are supplied without a door) may only be erected
in closed areas or in a protective cabinet or similar facility.