Endress+Hauser Levelflex FMP56 - Page 177

Levelflex FMP56, FMP57 FOUNDATION Fieldbus Operating menu
Endress+Hauser 177
Value 1 to 4 display 
Navigation  Setup → Advanced setup → Display → Value 1 display
Description Select the measured value that is shown on the local display.
Selection • None
7)
• Level linearized
• Distance
• Current output 1
8)
• Measured current
• Current output 2
• Terminal voltage
• Electronic temperature
• Analog output adv. diagnostics 1
• Analog output adv. diagnostics 2
Factory setting For level measurements
• Value 1 display: Level linearized
• Value 2 display: Distance
• Value 3 display: Current output 1
• Value 4 display: None
Decimal places 1 to 4 
Navigation  Setup → Advanced setup → Display → Decimal places 1
Description Select the number of decimal places for the display value.
Selection • x
• x.x
• x.xx
• x.xxx
• x.xxxx
Factory setting x.xx
Additional information The setting does not affect the measuring or computational accuracy of the device.
Display interval
Navigation  Setup → Advanced setup → Display → Display interval
Description Set time measured values are shown on display if display alternates between values.
User entry 1 to 10 s
7) can not be selected for the 'Value 1 display" parameter.
8) Visibility depends on order options or device settings