EasyManua.ls Logo

Endress+Hauser Levelflex FMP56 - Special Mounting Conditions

Endress+Hauser Levelflex FMP56
210 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Mounting Levelflex FMP56, FMP57 FOUNDATION Fieldbus
34 Endress+Hauser
6.1.6 Special mounting conditions
Concrete silos
Installation, for example, into a thick concrete ceiling should be made flush with the lower
edge. Alternatively, the probe can also be installed into a pipe that must not protrude over
the lower edge of the silo ceiling. The pipe should be kept at a minimum length.
Installation suggestions see diagram.
100
4
100
4
mm(in)
ø80...150
(ø3.2...6)
1
3
2
A0014138
1 Metal sheet
2 Metal tube
3 Extension rod / Centering HMP40 (see "Accessories")
Note for installations with rod extension/center washer (accessories): Strong dust
generation can lead to build-up behind the center washer. This can cause an interference
signal. For other installation possibilities please contact Endress+Hauser.

Table of Contents

Other manuals for Endress+Hauser Levelflex FMP56

Related product manuals