Endress+Hauser Liquiphant FTL64 - Mounting Considerations for Process Conditions; Temperature Management for PFA Coatings; Switch Point and Viscosity Factors

Liquiphant FTL64 Mounting
Endress+Hauser 13
1.
2.
A0042423
 10 Screwing in the device
Aligning the cable entry
2.
3.
4 3.5 Nm
1.
A0042355
 11 Housing with external locking screw and drip loop
The locking screw is not tightened when the device is delivered.
1. Loosen the external locking screw (maximum 1.5 turns).
2. Turn the housing, align the cable entry.
 Avoid moisture in the housing, provide a loop to allow moisture to drain off.