Need help?Do you have a question about the Endress+Hauser FEC 22 and is the answer not in the manual?
General| Electrical connection | M12 connector |
|---|---|
| Output | PNP/NPN |
| Protection class | IP67 |
| Power supply | 24 V DC |
| Process connection | G 1/2" |
| Voltage supply | 24 V DC |
Procedure for resetting the instrument to factory settings.
Procedure for calibrating the instrument with an uncovered probe.
Procedure for calibrating the instrument with a covered probe.
Details the intended and approved applications for the FEC 22 electronic insert.
Guidelines for operating the instrument in areas with explosion hazards.
Describes the intended use and applications of the FEC 22 electronic insert.
Explains the capacitive principle used for limit detection.
Outlines the components of a complete measuring system with the FEC 22.
Important notes before connecting the power supply.
Details how to connect the power supply cable to the electronic insert.
Describes the keys, rotary switch, and LEDs used for operation.
Explains the function of the LED chain and individual LEDs.
Procedure to restore the instrument to its default factory settings.
Step-by-step guide for calibrating the instrument with an uncovered probe.
Step-by-step guide for calibrating the instrument with a covered probe.
Recommendation for ensuring operational safety through dual calibration.
How to manually adjust the switch point difference (AC).
Automatic adjustment of the switch point to the measured material.
Configuration for fail-safe operation in various scenarios.
How to alter the switching delay time for the electronic insert.
Displays the deviation (dC) of measured capacitance from the set switch point.
Table listing common errors, causes, and remedies for the instrument.
Steps to safely remove the electronic insert from the probe housing.
Steps for correctly installing a new electronic insert.
Post-replacement procedure involving reset and recalibration.
Information and precautions for sending the electronic insert for repair.
Precautions for sending the probe for repair, especially regarding product traces.
Conformance of packaging to recycling regulations.
Information on instrument recycling and disposal services.
Manufacturer, designation, measuring principle, and signal processing details.
Details on installation and environmental conditions like temperature and ingress protection.
Information on housing design, dimensions, weight, material, and electrical connection.
Description of LEDs, keys, and rotary switch for interaction.
Specifications for AC and DC power supply versions.
List of certifications and approvals obtained by the product.
Order numbers for different versions of the FEC 22.
References to supplementary documentation and applicable standards.
To Next Page