Nivotester FTL325P single-channel Basic safety instructions
Endress+Hauser 5
2 Basic safety instructions
2.1 Requirements for the personnel
The personnel must fulfill the following requirements to carry out their tasks, e. g.
commissioning and maintenance:
‣
Trained specialists must have a qualification that is relevant to the specific function and
task.
‣
Must be authorized by the plant owner/operator.
‣
Must be familiar with national regulations.
‣
Must have read and understood the instructions in the manual and supplementary
documentation.
‣
Personnel must follow instructions and comply with general policies.
2.2 Designated use
• Use only as a transmitter supply unit
• Use only for point level switches from Endress+Hauser with two-wire-PFM signal
• Use only tools that have been insulated against ground
• Use only original parts
2.2.1 Incorrect use
The manufacturer is not liable for damage caused by improper or non-designated use.
Deviating application conditions may affect the level of protection. The correct functioning of
the device cannot be guaranteed.
2.3 Workplace safety
For work on and with the device:
‣
Wear the required protective equipment according to federal/national regulations.
2.4 Operational safety
Risk of injury!
‣
Operate the device only if it is in proper technical condition, free from errors and faults.
‣
The operator is responsible for ensuring failure-free operation of the device.
Modifications to the device
Unauthorized modifications to the device are not permitted and can lead to unforeseeable
dangers.
‣
If, despite this, modifications are required, consult with Endress+Hauser.
Repair
To ensure continued operational safety and reliability:
‣
Only perform repair work on the device if this is expressly permitted.
‣
Observe federal/national regulations pertaining to the repair of an electrical device.
‣
Use original spare parts and accessories from Endress+Hauser only.
To Next Page
Loading...
