Endress+Hauser Proline Prowirl F 200 - Setting the Medium Properties

Proline Prowirl F 200 PROFIBUS PA Commissioning
Endress+Hauser 87
‣
Pulse/frequency/switch output
→  108
‣
Totalizer 1 to 3
→  116
‣
Display
→  118
‣
Heartbeat setup
‣
Configuration backup display
→  120
‣
Administration
→  173
10.6.1 Setting the medium properties
In the Medium properties submenu the reference values for the measuring application
can be set.
Navigation
"Setup" menu → Advanced setup → Medium properties
‣
Medium properties
Enthalpy type
Calorific value type
Reference combustion temperature
Reference density
Reference gross calorific value
Reference pressure
Reference temperature
Reference Z-factor
Linear expansion coefficient
Relative density
Specific heat capacity
Calorific value
Z-factor
Dynamic viscosity