Endress+Hauser RIA15 - Certificates and Approvals

RIA15
Endress+Hauser 11
Operability
Local operation
1
2
3
4
5
6
7
8
A0017719
 4 Display and operating elements of the process display unit
1 Symbol: operating menu disabled
2 Symbol: error
3 Symbol: warning
4
Symbol: Communication active (only for HART
®
option)
5 Operating keys "-", "+", "E"
6 14-segment display for unit/TAG
7 Bar graph with indicators for under range and over range
8 5-digit 7-segment display for measured value, digit height 17 mm (0.67 in), display range -19999 to 99999
The device is operated with the 3 operating keys on the front of the housing. The device setup can be
disabled with a 4-digit user code. If the setup is disabled, a padlock symbol appears on the display
when an operating parameter is selected.
A0017716
Enter key; calling up the operating menu, confirming the option/setting parameters in the
operating menu
A0017714
Selecting and setting values in the operating menu; pressing the - and + keys simultaneously
takes the user back up a menu level. The configured value is not saved (ESC)
A0017715
RIA15 in conjunction with
the Micropilot FMR20
The RIA15 can be used for the basic setting of the Micropilot FMR20 radar level sensor.
For this, the RIA15 can either be ordered together with the FMR20 via the FMR20 product structure,
or the RIA15 must be ordered separately with option 3 "4 to 20 mA current signal + HART + FMR20
basic setting" in feature 030 "Input".
FMR20 product structure, feature 620 "Accessory enclosed":
• Option R4: "Remote display RIA15, non-hazardous"
• Option R5: "Remote display RIA15, hazardous"
RIA15 product structure, feature 030 "Input":
Option 3: "4 to 20 mA current signal + HART + FMR20 basic setting"
The following parameters can then be configured at the FMR20 via the 3 operating keys on the front
of the RIA15:
• Unit
• Empty and full calibration
• Mapping area if the measured distance does not match the actual distance
Certificates and approvals
CE mark
The measuring system meets the legal requirements of the applicable EC guidelines. These are listed
in the corresponding EC Declaration of Conformity together with the standards applied. Endress
+Hauser confirms successful testing of the device by affixing to it the CE mark.