Maintenance
Your Endurance
®
E400 Elliptical has been manufactured to withstand many hours of use with
minimal maintenance. Here are some maintenance tips to keep your Endurance
®
E400 Ellipti-
cal running at its best.
IF SQUEAKING NOISE OCCURS
Your Endurance
®
E400 Elliptical may occasionally require Multi-Purpose Grease to be applied
onto the underside of the foot pedal tube as shown. A small tube of Multi-Purpose Grease
was included with your unit and can also be purchased at most stores. DO NOT USE WD-40
OR SILICON SPRAY since these compounds will increase squeaking noise over time.
Apply the Multi-Purpose Grease onto the bottom of both foot pedal tubes in the area that
makes contact with the roller wheel as shown below. During normal usage (30 minutes of
exercise per day), Multi-Purpose Grease is to be applied every 3 months or as needed.
CLEANING
Periodically wipe down your machine with mild, soapy water or a diluted general purpose
non-abrasive household cleaner. Cleaner should never be applied directly to any part of the
equipment. Instead, place the non-abrasive cleaning solution on a soft cloth and wipe down
the unit. The elliptical should be wiped down to remove sweat after each use.
ERROR MESSAGES
The E400 console is equipped with auto-diagnostic technology if any fault to the machine
is to occur in order to protect the safety of the user and the integrity and reliability of the
machine. The E400 console automatically checks the brake motor status every time the unit
is powered on. If the brake motor does not reply to the console’s diagnostic call or does not
move to its target position within 2 seconds, the console will display the error message ‘MO-
TOR ERROR’ immediately and disable button operation until power is reset. To clear the error
message, unplug then plug in the unit.
If the console still displays the error message ‘MOTOR ERROR’, contact an authorized Endur-
ance
®
dealer or an Endurance
®
factory-authorized service company or contact Endurance
®
Customer Tech Support at 1-800-556-3113
.
20
Maintenance Instructions
IF SQUEAKING NOISE OCCURS -
Your Keys Fitness Elliptical may occasionally require Multi-Purpose Grease to be applied onto
the underside of the foot pedal tube as shown. A small tube of Multi-Purpose Grease was
included with your unit. Multi-purpose Grease can also be purchased at most stores or you can
call Keys Fitness Customer Service at (888) 340-0482. DO NOT USE WD-40 OR SILICON SPRAY
- This will increase squeaking noise over time.
Apply the Multi-Purpose Grease onto the bottom of both foot pedal tubes in the area that
makes contact with the roller wheel.
Apply grease to this area
Roller Wheel
CLEANING/MAINTENANCE -
Your CG3 Elliptical has been manufactured to withstand many hours of use with minimal
maintenance.
Periodically wipe down your machine with mild, soapy water or a diluted general purpose
household cleaner. Machine should be wiped down to remove sweat after each use.
Correct Grease Application
Apply grease to this area
Roller Wheel
48
To Next Page
Loading...
