Step 1 Step 1
IMPORTANT:
DO NOT tighten hardware until instructed to do so.
A. Slide Upright (F) slightly into Mainframe (A) as shown.
B. Connect the harness from Upright (F) to the harness on Mainframe
(A).
C. Completely slide Upright (F) into Mainframe (A) and secure using:
Three 168 (M10x80 allen head bolt)
Nine 87 (M10 at washer)
Three 96 (M10 crown nut)
Three 70 (M10x120 allen head bolt)
NOTE: Be careful not to pinch wires.
6
To Next Page
Loading...
