Endurance T50 - Troubleshooting Guide

1. Insufcient lubrication. 1. Apply silicone lubricant.
Running Belt Hesitates
When Stepped On.
2. Running belt too tight.
2. Adjust running belt
tension.
Treadmill Will Not Start.
1. Running belt not tight.
1. Adjust running belt
tension.
Running Belt Slips.
2. Drive belt not tight.
2. Adjust drive belt tension.
Problem Potential Cause Correction
1. Not plugged in.
1. Plug into grounded
outlet.
2. Safety key not inserted.
2. Insert safety key into
console.
3. House circuit breaker
3. Reset or replace fuse.
tripped.
4. Treadmill circuit breaker 4. Lubricate treadmill deck
tripped. and reset.
5. On/Off switched <OFF>.
5. Turn On/Off switch to
<ON>.
Running Belt Is Off
1. Running belt tension not
1. Center the running belt.
Centered.
even across rear roller.
Troubleshooting Guide
34