12
ENFORCER Vandal Resistant Access Control Keypads
SECO-LARM U.S.A., Inc.
Programming Format and Default Programming Values:
In this manual, the format used for programming the keypad is as follows:
• A 2-digit (
XX
) FUNCTION identier to tell the keypad what is being programmed.
• A varying number of digits (
X
) to represent the parameters of that FUNCTION.
• The
#
key to conrm programming of the FUNCTION.
The following is a list of the different programming functions:
Function Parameters Default functions and values Page #
01 Master code Default 0000, code length from 4~8 digits 13
02 Super user code No default, must be programmed 14~15
03 Common user code for output #1 No default, must be programmed 15~16
04 Common user code for output #2 No default, must be programmed 15~16
10 User codes/cards* for output #1 No default, must be programmed 16~17
20 User codes/cards* for output #2 No default, must be programmed 16~17
40 Visitor codes for output #1 No default, must be programmed 17~18
41 Duress codes for output #1 No default, must be programmed 19~20
42 Duress codes for output #2 No default, must be programmed 19~20
51 Output mode for output #1 5-Second output, momentary 21
52 Output mode for output #2 5-Second output, momentary 21
55 System real-time clock No default, must be programmed 22
56 Output #1 auto-disable time No default, must be programmed 22~23
60 Wrong-code system lock-up Locks keypad after 10 false code/card tries 24
70 User code entry mode Manual entry of “#” after each code 24-25
71 Keypad sounds Programming and operation beeps enabled 25
72 Output relay activation sounds 1-Second beep when output is activated 25
73 Center LED standby ashing Center LED ashes on standby 26
80 Door-forced-open warning Warning disabled 26
81 Door-propped-open warning Warning disabled 27
90 Egress delay/warning/alarm Egress output happens immediately 28~29
NOTE: The Direct Access to Programming (DAP) code 2828 (page 29) and the system restore
code 9999 (page 13) are xed and cannot be changed, even via programming.
*SK-1123-SPQ only
To Next Page
Loading...
Need help?
General
