15
ENFORCER Vandal Resistant Access Control Keypads
SECO-LARM U.S.A., Inc.
Programming the Super User Code (cont.):
Programming Common User Codes*:
3. To toggle operation of output #1 ON or OFF:
2580 # 7
NOTE:
• This function is used to leave output #1 active for extended periods of time.
• Do not forget to deactivate this function after its use is no longer required.
• It is recommended to only use this function with fail-safe locks.
4. To temporarily pause or restart the timed output #1 disable period:
2580 # 8
NOTE:
• This function is used to enable the operation of output #1 if it was disabled using the output
#1 auto-disable function (see pages 22~23).
• When the output #1 auto-disable function is inactive, the red LED will ash steadily. This
indicates that output #1 may now be used.
5. Disable or enable output #1 (toggle, regardless of programming):
2580 # 9
NOTE:
• For more information on programming timed or toggle mode, see “Programming the Output
Mode and Output Timing” on page 21.
• The right LED will remain red while output #1 is disabled.
• For safety reasons, the egress button works regardless of whether output #1 is enabled or
disabled via the super user code.
• The super user code continues to operate output #1 even while that output is disabled.
This function allows a common user code to be automatically added to each proximity card as it is
programmed. Every proximity card user also uses the same common user code to operate outputs
#1 or #2. This provides greater security than programming the keypad to operate with the card
alone. It is also more convenient than assigning each user a unique user code, although unique
user codes offer an even greater degree of security.
1. To program a common user code for output #1:
03 xxxx #
2. To program a common user code for output #2:
04 xxxx #
3. To delete a common user code output #1:
03 #
*SK-1123-SPQ only
To Next Page
Loading...
Need help?
General
