14
ENFORCER Vandal Resistant Access Control Keypads
SECO-LARM U.S.A., Inc.
Programming the Super User Code:
The super user code has two functions:
• Unlike user codes, the super user code can activate or deactivate output #1 and output #2.
• The super user code can also enable or disable output #1. An administrator may want to disable
output #1 in the evening or on the weekend to prevent other users from entering a protected
premises.
• The super user code is exempt from any system inhibition or lockup functions. It is valid at any
time.
Programming the Super User Code:
1. Make sure the keypad is in programming mode (see “Enter and Exit Programming Mode” on
page 11).
2. Enter the new super user code:
02 xxxx #
NOTE:
•
XXXX
represents the new super user code, which can be 4 to 8 digits long.
• There can be only one super user code for the keypad.
• Programming a new super user code will overwrite the previous super user code.
• The master code, super user code, common user codes, and user codes cannot
be the same.
Deleting the Super User Code:
This function is useful for protecting the premises in case the super user code is forgotten.
To delete a super user code:
1. Make sure the keypad is in programming mode (see page 11).
2. Enter:
02 #
Using the Super User Code:
In these examples, assume the super user code is
2580
.
1. Activate or deactivate output #1 (timed or toggle, depending on programming):
2580 # 1
2. Activate or deactivate output #2 (timed or toggle, depending on programming):
2580 # 2
To Next Page
Loading...
Need help?
General
