ENFORCER SK-1323-SPQ User Manual

ENFORCER Outdoor Stand-Alone Keypads
12 SECO-LARM U.S.A., Inc.
Deleting or Changing the Master Card*
Programming Output #2
Each Output #2 user may only have a user code OR a user card programmed.
*SK-2323-SPQ and SK-1323-SPQ only.
6. Exit Programming Mode by pressing .
C. User Card and Code*
3. Swipe a new user card.
1. Enter a user ID number.
5. To program the next user, repeat from step 1 in section A, B, or C.
4. Enter a new user code.
2. If the left LED is red, previous user data exists. Clear it by entering . The keypad will beep in
confirmation and the left LED will turn green.
( to )
0
0
0
9
9
9
Note – For all of the following programming functions, the keypad must be in Programming Mode. To enter
Programming Mode, enter the Master Code twice.
Continued from page 11.
B. Programming an Output #2 User Card*
A. Programming an Output #2 User Code
5. To program the next user, repeat from step 2 in section A or B.
7. Exit Programming Mode by pressing again.
4. Swipe a new user card.
2. Enter a user ID number.
6. Return to Programming Mode by pressing .
1. Enter .
4
3. If the left LED is red, previous user data exists. Clear it by entering . The keypad will beep in
confirmation and the left LED will turn green.
( to )
0
0
0
9
Deleting or Changing Users and Cards
7
Enter:
Step 1
Step 2
Step 3
Delete the existing Master Card by entering:
Swipe a new Master Card.
or
Exit Programming Mode by entering .
7. Exit Programming Mode by pressing again .
4. Enter a new user code.
2. Enter a user ID number.
5. To program the next user, repeat from step 2 in section A or B.
6. Return to Programming Mode by pressing .
1. Enter .
4
3. If the left LED is red, previous user data exists. Clear it by entering . The keypad will beep in
confirmation and the left LED will turn green.
( to )
0
0
0
9

ENFORCER SK-1323-SPQ Specifications

General

Brand	ENFORCER
Model	SK-1323-SPQ
Category	Keypad
Language	English