EasyManuals Logo

ENFORCER SK-1323-SPQ User Manual

ENFORCER SK-1323-SPQ
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
ENFORCER Outdoor Stand-Alone Keypads
10 SECO-LARM U.S.A., Inc.
4. Exit Programming Mode by pressing .
Program a new Master Code immediately.
Take note of the keypad status LEDs
o Right LED Solid Green: Standby Mode
o Right LED Solid Orange: Programming Mode
o Left LED Solid Green / Right LED Flashing Orange: Awaiting code/card entry
If you are unsure of which mode the keypad is in, press until the right LED is green. The keypad is now
in the Standby Mode. Enter the master code twice to return to Programming Mode.
Enter:
1. Codes are programmed to have 2~6 digits in length. All codes must be the same length.
2. Before inputting any of the following, enter Programming Mode by entering the
Master Code twice. The default Master Code is 1234.
To enter Programming Mode, enter
3. To exit Programming Mode, press the key.
4. The keypad will exit Programming Mode if no keys are pressed for 30 seconds.
Programming Instructions
#
Programming Tips
#
First Time Keypad Use
Take these steps the first time the keypad is programmed.
1. Enter Programming Mode by entering the Master Code twice. (Default Master Code is 1234).
2. Enter
3. Enter the new Master Code twice. The Master Code may not be the same as a user code.
C. Program the Master Code
3
Example: If the desired new Master Code is 4321, enter:
4
3
2
1
4
3
2
1
4. Exit Programming Mode by pressing .
A. Enter Programming Mode
(Default Master Code is 1234).
*SK-2323-SPQ and SK-1323-SPQ only.
B. Program Code Length
1. Enter Programming Mode by entering the Master Code twice. (Default Master Code is 1234).
2. Enter
9
3. Enter the desired code length. This must be a number from 2~6.
WARNING: After a new code length is programmed, all user codes will be deleted and master code will
be reset.
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
Note: The Master Code will reset depending on the programmed code length. These will be the new
Master Codes after the code length is reset:
Code Length
New Master Code
2 digits
12
3 digits
123
4 digits
1234
Code Length
New Master Code
5 digits
12345
6 digits
123456
0
4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ENFORCER SK-1323-SPQ and is the answer not in the manual?

ENFORCER SK-1323-SPQ Specifications

General IconGeneral
BrandENFORCER
ModelSK-1323-SPQ
CategoryKeypad
LanguageEnglish

Related product manuals