EnGenius EAP600 Quick Installation Guide

Quick Installation Guide
EAP600
Wireless-N 300 + 300Mbps Long Range Ceiling Mount Dual
Concurrent AP
Please verify contents of the box before continuing to set up the EAP600.
 EAP600 Access Point
 12V/2A 100V~240V Power Adaptor
 RJ-45 Ethernet Cable
 Mounting Bracket
 Wall/Ceiling Mounting Hardware Kit
 T-Rail Mounting Hardware Kit
 CD with User's Manual
Connecting the EAP600
1) Ensure that the computer in use has an Ethernet Card (RJ-45 Ethernet Port). For more information,
verify with User Manual.
2) Connect one end of the Category 5e Ethernet cable into RJ-45 port of the EAP600 and the other
end to the RJ-45 port on the computer that will use the EAP600. Ensure that the cable is securely
connected to both the EAP600 and the Computer.
3) Connect the Power DC Inlet to the DC-IN port of the EAP600 and the Power to the electrical out.
Note: EAP600 supports both IEEE 802.3at PoE(Power over Ethernet) and regular power adapter. You
should use either one as the power source. Please do not apply both at the same time.

EnGenius EAP600 Specifications

General

Modulation	16-QAM, BPSK, CCK, DBPSK, DQPSK, OFDM, QPSK
Frequency band	2.4, 5 GHz
Operating modes	Access Point (AP), Repeater, WDS Access Point (AP), WDS Bridge
Channel bandwidth	40 MHz
Channels quantity	13 channels
Transmitting power	16 dBmW
Networking standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3af, IEEE 802.3at
Receiver sensitivity	-99 - -68dBm
Virtual LAN features	Tagged VLAN
Wi-Fi data rate (max)	54 Mbit/s
Spread spectrum method	DSSS
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	300 Mbit/s
Quality of Service (QoS) support	Yes
Networking features	Gigabit Ethernet
Wireless technology	IEEE 802.11a/b/g/n
Internal	No
Placement	Ceiling, Wall
Certification	FCC, IC, CE
Product color	White
USB 2.0 ports quantity	0
Ethernet LAN (RJ-45) ports	1
VPN support	IPsec, L2TP, PPTP
Security algorithms	128-bit WEP, 64-bit WEP, 802.1x RADIUS, SSID, WPA-EAP, WPA-TKIP
Number of SSID supported	16
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	0 - 90 %
Input current	2 A
AC input voltage	12 V
Power requirements	90 - 240 VDC ± 10%, 50/60 Hz; 48 VDC/0.375A
Cables included	LAN (RJ-45)
Flash memory	8 MB
Internal memory	64 MB
Antenna features	Integrated antenna
Antennas quantity	6
Antenna gain level (max)	5 dBi

Weight and Dimensions

Width	161.5 mm
Height	41.5 mm
Weight	290 g
Dimensions (WxDxH)	161.5 x 161.5 x 41.5 mm