EasyManuals Logo

EnGenius EAP600 Mounting

EnGenius EAP600
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Mounting the EAP600
Using the provided hardware, the EAP600 can be attached to a ceiling or wall.
To attach the EAP600 to a ceiling or wall using the mounting bracket:
1) Attach the mounting bracket to the wall or ceiling using the provided wall/ceiling mounting
hardware kit.
2) Insert the provided short screws into the bottom cover of the EAP600.
Leave enough of the screws exposed to ensure that the unit can be attached to the mounting bracket.
If extra space is required, use the provided spacers and long screws from the T-Rail mounting
hardware kit to increase the space between the unit and the mounting bracket.
3) Mount the EAP600 on the mounting bracket by rotating the unit clockwise about 90 degrees to
secure it in place.

Other manuals for EnGenius EAP600

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EnGenius EAP600 and is the answer not in the manual?

EnGenius EAP600 Specifications

General IconGeneral
Modulation16-QAM, BPSK, CCK, DBPSK, DQPSK, OFDM, QPSK
Frequency band2.4, 5 GHz
Operating modesAccess Point (AP), Repeater, WDS Access Point (AP), WDS Bridge
Channel bandwidth40 MHz
Channels quantity13 channels
Transmitting power16 dBmW
Networking standardsIEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3af, IEEE 802.3at
Receiver sensitivity-99 - -68dBm
Virtual LAN featuresTagged VLAN
Wi-Fi data rate (max)54 Mbit/s
Spread spectrum methodDSSS
Ethernet LAN data rates10, 100, 1000 Mbit/s
Maximum data transfer rate300 Mbit/s
Quality of Service (QoS) supportYes
Networking featuresGigabit Ethernet
Wireless technologyIEEE 802.11a/b/g/n
InternalNo
PlacementCeiling, Wall
CertificationFCC, IC, CE
Product colorWhite
USB 2.0 ports quantity0
Ethernet LAN (RJ-45) ports1
VPN supportIPsec, L2TP, PPTP
Security algorithms128-bit WEP, 64-bit WEP, 802.1x RADIUS, SSID, WPA-EAP, WPA-TKIP
Number of SSID supported16
Storage temperature (T-T)-20 - 60 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)0 - 90 %
Input current2 A
AC input voltage12 V
Power requirements90 - 240 VDC ± 10%, 50/60 Hz; 48 VDC/0.375A
Cables includedLAN (RJ-45)
Flash memory8 MB
Internal memory64 MB
Antenna featuresIntegrated antenna
Antennas quantity6
Antenna gain level (max)5 dBi
Weight and Dimensions IconWeight and Dimensions
Width161.5 mm
Height41.5 mm
Weight290 g
Dimensions (WxDxH)161.5 x 161.5 x 41.5 mm

Related product manuals