Engl INVADER II - Page 23

53 FX Loop II Send
54 FX Loop II Return
55 Balance
Low / High Gain - Volume Ratio Control: Channel 1
57 Low / High Gain - Volume Ratio Control: Channel 2
58Low/HighGain-VolumeRatioControl:Channel3
59 Low / High Gain - Volume Ratio Control: Channel 4
Connect this FX Loop II output to a signal processor's input/return jack using the
shortestpossibleshieldedcordequippedwith1/4"plugs.Activateanddeactivateitvia
the FX Loop I/II (16) button, which switches between these two loops. In the signal
path, islocatedpostpreampandprethetwopowerampMasterknobs.
Connect this FX Loop II input to a signal processor's output/send jack using the
shortestpossibleshieldedcordequippedwith1/4"plugs.Activateanddeactivateitvia
the FX Loop I/II (16) button, which switches between these two loops. In the signal
path, islocatedpostpreampandprethetwopowerampMasterknobs.
FX mix control for . When the knob is set to , the amp signal is routed
through with no processed signal (0% wet balance) added to the mix. Twist the knob
clockwise to blend in the processed signal (parallel/passive, wet balance 1-99%,
depending on knob position). When the knob arrives at the Effect position, only the
wet signal (that is, the processed signal generated by the connected effect device) is
patchedtothepoweramp(serial,100%wet).
Setthisknobto whenthisloopisnotinuse!
This knob adjusts the balance of volume levels between in Low Gain mode
and inHighGainmode.Itssettingaffects inHighGainmodeonly.
The volume level of in Low Gain mode is determined by the Channel 1
Volume knob (6) setting. Use knob 56 to dial in the relative volume to in
HighGainmode.
This knob adjusts the balance of volume levels between in Low Gain mode
and inHighGainmode.Itssettingaffects inHighGainmodeonly.
The volume level of in Low Gain mode is determined by the Channel 2
Volume knob (24) setting. Use knob 57 to dial in the relative volume to in
HighGainmode.
This knob adjusts the balance of volume levels between in Low Gain mode
and inHighGainmode.Itssettingaffects inHighGainmodeonly.
The volume level of in Low Gain mode is determined by the Channel 3
Volume knob (12) setting. Use knob 58 to dial in the relative volume to in
HighGainmode.
This knob adjusts the balance of volume levels between in Low Gain mode
and inHighGainmode.Itssettingaffects inHighGainmodeonly.
The volume level of in Low Gain mode is determined by the Channel 4
FXLoopII
FXLoopII
FX Loop II Dry
Dry
Channel 1
Channel1 Channel1
Channel 1
Channel 1
Channel 2
Channel2 Channel2
Channel 2
Channel 2
Channel 3
Channel3 Channel3
Channel 3
Channel 3
Channel 4
Channel4 Channel4
Channel 4
NOTE:
56
23