Safety g uidelines f or electric bike
1. Do not park the electric bike in the building lobby, evacuation stairs, walkways or safety
exits.
2. Do not charge and park the electric bike in the residential building. Keep the bike away from
combustibles during charging. The charging time should not be too long, generally not more
than 12 h.
3. Prevent water from entering the electrical components. When cleaning the bike, avoid
water flow impacting the charging interface, harness connectors and other electrical
components.
4. When adjusting the height of the saddle and stem, be careful not to expose the safety scales
on the saddle and stem.
5. Users and dealers are prohibited from modifying the bike without authorization. For
example: modification of battery configuration, modification of circuit, increase of bulb
1. It is strictly prohibited for persons under 16 years of age to drive electric-assisted bicycles
on the road, and do not lend them to people who will not be able to manipulate the
electric-assisted bicycle.
2. Please drive in non-motorised lanes and do not exceed the maximum speed limit of local
regulations.
3. Electrically-assisted bicycles should carry persons or objects in accordance with the law.
4. Always wear a proper safety helmet and fasten the helmet harness while riding.
Driving s afety: Please observe national and local traffic regulations and pay attention to driving safety.
power, add-on installation of audio devices, etc..
6. Do not touch the live components of the electric bicycle with wet hands or metal objects.
For example: the battery interface, battery charging port, charger connector, etc..
7. Do not disassemble the electrical components without authorization to prevent liquid and
metal filings from entering the components. 8. Do not expose the bike to sunlight/rainstorm
for a long time to prevent parts from aging.
9. If the bike needs to be cleaned, please wipe down the frame using water mixed with a
neutral detergent. Do not remove and wash the internal parts with water to prevent short
circuits.
5. Riding in rainy or snowy days, the braking distance will be lengthened, so pay attention to
decelerating and slowing down. in inclement weather such as rainstorms, try to Use by
people travelling in vehicles to avoid danger.
6. Please observe traffic rules carefully and do not drink and drive, drive with one hand or
ride with both hands spreading the handlebars.
7. Try to wear brightly coloured clothes that are not too tight, with open cuffs and that allow
you to move around freely, and wear low-heeled shoes or trainers wherever possible.
maintenance Precautions
Note: Non-professionals are strictly prohibited from carrying out maintenance, and should contact customer service or go to our designated professional maintenance station for
maintenance in case of failure.
Pre-Ride Inspection
1. Turn on the power, check whether the indicators on the instrument are normal, and check
whether the power supply is sufficient;
2. Check whether the front and rear lighting is normal, and whether the angle of the headlight
lighting is normal.
3. Check that the horn of the electrically-assisted bicycle is in good sounding condition.
4. Check that the handlebar and seatpost are adjusted to the proper position and make sure
that the fastening screws (or quick release) are tight.
Notes on the way
1. For your safety and the safety of others, please consciously abide by traffic rules.
2. Before riding, you must wear a safety helmet, as well as take other relevant safety
precautions.
3. When the vehicle is first started, accelerate slowly so as not to accelerate too quickly and
lose control.
3. When stopping the car, you should support the foot support on the level ground and turn
off the power.
4. Please maintain and clean the car regularly to keep it in the best condition.
5. Check the brake handle, brake commissioning should make the brake reliable, reset
flexible, the tail light should be on when braking.
6. Check whether the tyre pressure is normal, there are no cracks and abnormal wear and
tear, as well as nails, stones, glass and other sharp objects into the Tire.
7. Check that the wheel screws are locked and that the stirrup reflectors are not lost, broken
or contaminated.
4. In rainy and snowy weather, the braking distance should be increased appropriately, and
you should concentrate on riding slowly and cautiously to prevent side-slipping and falling.
5. Before stopping, please lower the mechanical gear for the next ride.
Pushing and parking precautions
1. Turn off the power switch when pushing to prevent accidents caused by unintentionally
turning the throttle when pushing.
2. When pushing uphill or carrying heavy objects, you can turn on the boost mode to assist in
pushing.
3.1 maintenance Precautions
To Next Page
Loading...