Software Release: [App: 02.09.10051.00; Config: 2.9.20024; Built in PowerVision Configuration Studio Version: 2.9.23042;
BTL: 02.09.10015.00]
Section 40 29 00-02-0939
2019-06-13
Brightness (Medium Security): allows the backlight of the screen to be adjusted. Factory set to 90.
Parameter Setup (Low Security): allows four-up Page 1 and Page 2 parameters to be changed without
using a PC.
Backlight Control (Medium Security): turns off (disables) or on (enables) the screen’s backlight. Factory
set to Enable.
Standby Timer (Medium Security): allows the screen the designated amount of time before the controller
goes into Standby mode. Standby is also referred to as sleep mode. Factory set to 00:30:00.
Service Reminders (Medium Security): when the service reminder is set to 0, the alarms will be disabled;
however, the countdown will continue and will show the numbers as (-) numbers as it counts down past 0
for the following parameters: All service reminders factory set to 0.0 Hrs. If service reminders are
desired they should be set within this menu.
Show Service Screens (Medium Security): factory set to Hide.
Oil Life (Medium Security): factory set to 0 Hrs
Reset Oil Life (Medium Security): resets Oil Life reminder to factory setting.
Oil Filter Life (Medium Security): factory set to 0 Hrs
Reset Oil Filter Life (Medium Security): resets Oil Filter Life reminder to factory setting.
Belt Life (Medium Security): factory set to 0 Hrs
Reset Belt Life (Medium Security): resets Belt Life reminder to factory setting.
Battery Life (Medium Security): factory set to 0 Hrs
Reset Battery Life (Medium Security): resets Battery Life reminder to factory setting.
Fuel Filter Life (Medium Security): factory set to 0 Hrs
Reset Fuel Filter Life (Medium Security): resets Fuel Filter Life reminder to factory setting.
Air Filter Life (Medium Security): factory set to 0 Hrs
Reset Air Filter Life (Medium Security): resets Air Filter Life reminder to factory setting.
Overhaul Life (Medium Security): factory set to 0 Hrs
Reset Overhaul Life (Medium Security): resets Overhaul Life reminder to factory setting.
Reset All (Medium Security): Resets all service reminders to factory setting.
ECU Fault Codes (Medium Security): allows the operator to request stored fault codes from the ECU
and request to clear active as well as stored codes in the ECU.
Stored Fault Codes (Medium Security): allows the operator to query the Engine ECU for review
of its stored fault codes.
Clear Active ECU Fault Codes (High Security): Clears any active fault codes broadcast from the
ECU as long as the ECU accepts the request.
Clear Stored ECU Fault Codes (High Security): Clears any stored fault codes in the ECU as
long as the ECU accepts the request.
Auto / Manual (Low Security):
To Next Page
Loading...
Need help?
General
