00-02-0796 - 15 - 2013-04-08
To select USE DEFAULTS, highlight the option and
press Enter. A message indicating “RESTORED TO
DEFAULTS” is displayed.
2. Custom Setup – In this option, select the parameters
and order in which they will be displayed. The list is
long; continue to scroll until you have seen all available
parameters. To select Custom Setup, highlight and
press Enter. A list of engine parameters displays.
NOTE: The PV101 must see the parameter being
broadcast over J1939 in order to select the parameter
from the list.
To select a parameter, use the Arrow Keys to scroll
and highlight the parameter, then press Enter.
Selected parameters are indicated by a number to the
right of it. The numbers represent the order in which the
parameters will be displayed.
To deselect a parameter and remove it from the list of
displayed parameters, highlight the parameter and
touch Enter.
To Next Page
Loading...
Need help?
General
