Enovation Controls Murphy PowerView PV101-C User Manual

00-02-0796 - 38 - 2013-04-08
 NO STORED CODES is displayed
The PowerView sent a request to the ECU for Stored Fault
Code (DM2) information. The ECU responded: There are
zero stored codes.
 NO GAGE DATA is displayed
The PowerView has no record of gages connected to the
RS485 bus.
 NO DATA is displayed in place of a parameter value
The PowerView has not received data for the selected
parameter for at least 5 seconds.
 NOT SUPPORTED is displayed in place of a parameter
value
This means the data received for this parameter is not valid
or not supported.

Enovation Controls Murphy PowerView PV101-C Specifications

General

Brand	Enovation Controls
Model	Murphy PowerView PV101-C
Category	Monitor
Language	English