Enovation Controls Murphy PowerView PV380-R2 - Page 30

00-02-0997 31 2016-06-15
Review the table below to be informed of specific
parameters for each type:
Engine
Type
Specific Parameters Available
Electronic
• DPF (enabled or disabled)
• SCR (enabled or disabled)
• ECU Source Address (default: ALL)
• Display Source Address (default: 43)
• Overspeed
o Shutdown
 % Over High Speed
 Fault at High Speed
o Warning
 % Over High Speed
 Fault at High Speed
o Disabled
• Machine Hours
o Set Machine Hours
o Clear Machine Hours