10
syncing two bases (optional)
STEP 3
STEP 2
STEP 1
STEP 4
A Sync Cord is included with the base. Not available on Queen, Full or Full-Long size bases.
The Sync Cord connects the two control boxes to a single remote for the synchronization of two bases.
Plug bases back into the power source.
If bases become mismatched, pressing the FLAT button will
re-sync the mechanical positions.
Connect the male end of each Sync Cord to Control Box or
splitter cable.
Check to ensure all cords are securely attached. Both remotes
will now operate both bases simultaneously.
Unplug bases from power source.
PERFORMANCE NOTES
Control Box 1 Control Box 2
The system is now linked. Buttons pressed on either remote
will control both bases simultaneously.
Sync Cord
To Next Page
Loading...
