7
installation guide
To install the legs, unscrew the spacer on the four bed leg hole
sites, thread the washer over the bolt of the leg with the recessed
side facing the leg, and tighten by hand. Do not over tighten.
9 inch leg
9 inch
leg install
3 or 6
inch leg
install
3 inch leg
6 inch leg
STEP 1
STEP 2
With the help of an able-bodied assistant, place the carton on the
floor with the arrows pointing downwards.
Remove the binding straps and packing materials, making sure not
to puncture the box with any sharp objects.
Remove the bed base from the box, unfold the bed, then make
the bottom of the base facing upwards.
STEP 3
For customer support, visit www.ergomotion.com or call: 1-844-534-3676
To Next Page
Loading...
