14
A Sync Cord is included with Twin Long and Split King bases only. Not available on Queen, Full or Full-Long size
bases. The Sync Cord connects the two control boxes to a single remote for the synchronization of two bases.
STEP 3
STEP 2
STEP 1 STEP 4
STEP 5
STEP 6
syncing two bases (optional)
Unplug base from power source.
Plug base back into the power source.
Check to ensure all cords are securely attached. Both remotes
will now operate both bases simultaneously (If the remotes
become unpaired, see page 12).
Disconnect the power-down box from the control box or splitter
cable. Make note where the cable was plugged in.
Connect the male end of the sync cord to each control box or
splitter cable. Insert it into the same port you disconnected the
power-down box from in Step 2.
Connect each power-down box male connection to the sync
cord female connection (Refer to the illustration below).
Powerdown box Powerdown box
Control Box
Bed A
Sync Cord
Control Box
Bed B
To Next Page
Loading...
