Integrated safety
To permit a safe passage between closing doors, the doors reverse immediately if an obstruction is
detected. They then resume their interrupted movement at low speed to check whether the obstruc-
tion has disappeared or not.
If an obstruction is detected while the door is opening, the doors stop immediately, and then close
after a time delay.
Safety system with presence sensors
Usually the safety system incorporates presence sensors installed above the door opening. A presence
sensor detects an object in the doorway, while the doors are closing, the doors reverse immediately.
The doors will start to close when the object is removed.
Technologically advanced sensors
The Entrematic Group sensors have been tested and approved by the Entrematic Group test labor-
atory for use on Entrematic Group's automatic sliding doors. These presence sensors further improve
the already high obstruction detection obtained with the built in self-monitored crush force limitation.
Monitored sensors have built-in monitoring for error detection.
Note! If you have a problem you cannot correct, turn off the automatic door immediately and call
your Entrematic Group service representative for assistance.
9Issue 2019-06-281005274-EMen-9.0
To Next Page
Loading...
