22 Printer Installation
c. Press the up or down arrow to display Static IP on
line 3.
d. Press E
NTER to enter the Static IP menu.
6. Set the static IP address, subnet mask, and gateway
address.
a. Press E
NTER with IP Address on line 3 to set the static IP
address.
The IP address has four sections, separated by periods.
i. The address section shows three digits when it can
be changed. Use the arrow keys to change the
right-most digit one number at a time. Press E
NTER
to save the value and navigate to the next section
of the address.
ii. Press E
NTER When all four sections are correct. The next section of the address entry
(Subnet Mask or Gateway Address) displays on line 3.
b. Repeat step a to enter the subnet mask and gateway
address.
7. Press E
NTER when you finish entering all the required
address information. Apply displays on line 3.
8. Press E
NTER to apply your changes.
9. Press the down arrow key until Exit displays on line 3.
10. Press E
NTER. Then, press the USER button to return the printer to Ready.
11. Power off and restart the printer to verify that the static IP address is correct.
To Next Page
Loading...
Need help?
General
