3. Please ensure that the current network your phone connect to is 2.4GHz WiFi,
and the connection between your router and the Internet is in good condition.
c. Connect the network whose name is as same as your EVT’s SN, and return to
the app. Please allow Enverview app to find and connect to devices on your
local network. If not, it also causes configuration failure.
Note: When configuring WiFi, make sure you keep staying on the current
connection.
d. Click Configuration and wait for success.
Note: If the setting is not successful, wait 5 seconds. Click Configuration again
and check that the EVT800 is as close to the router as possible.
Option 2. Use computer to configure WiFi
1. Go to your computer’s WLAN setting. Connect a network of the same name
as your EVT microinverter Serial Number.
2. Use a browser to open the webpage: http://10.10.100.254 . Log in to the
account with the credentials below. Username: admin Password: admin
3. Click "STA Setting" for the relevant configuration, and click "Scan" to scan
To Next Page
Loading...
Need help?
General
