SLIDER/DAMPER INSTALLATION /OPERATIONS INSTRUCTIONS
This is used to regulate the airflow through the pellet stove.
INSTALLATION:
1. Remove the slider rod (short rod with knob and nuts) and the two nuts from their package and open
the left side panel. This is the smaller of the two rods. Remove the knob from the knob.
2. Remove the knob and the outer nut from the rod. Push the rod through the hole in the slider. Place
the other nut on the rod and tighten, leaving a 1/32” gap between the slider and one of the other
nuts.
3. Make sure the slider moves freely. Close the left side panel and the tighten screws. Push the rod
through the hole in the side panel. Screw the knob on to the slider rod.
OPERATION:
1. On the low heat output settings, push the slider all the way in.
2. On the high heat output pull the slider out until a good fire is achieved. A good fire is in between a
fire with lazy flames (black tipped flames) and a forced fire (very quick, shorter flames). A good fire
is the most efficient and will have a bright and active flame.
3. Hot magnehelic reading 0.10--0.12
ON HIGH
Pull out until an
efficient flame is
achieved
ON LOW
Push all the
way in
THE SCRAPER ROD:
Push the stainless steel rod through the hole in the heat exchanger, thread the
rod into the scraper plate.
7
To Next Page
Loading...
Need help?
General
