Name: Enviro EF-III BAY I FS
Brand: Enviro
Rating: 4 (1 reviews)

To Next Page

To Previous Page

FREESTANDING OUTSIDE VERTICAL INSTALLATION

To accomplish the above titled installation, follow steps 1 through 8 in the previous section and then

finish it by performing the following.

9. Install a tee with clean out on the outside of the house.

10. Install PL vent upward from the tee. Make sure that you install support brackets to keep the

vent straight and secure.

11. Secure the flashing as you go through the roof.

12. Ensure that the rain cap is approximately 36” (900 mm) above the roof.

1”

Questions and Answers:

Need help?

Do you have a question about the Enviro EF-III BAY I FS and is the answer not in the manual?

Enviro EF-III BAY I FS Specifications

General